|
The dividers were cut and placed to fit perfectly for the items I
intend to carry. I finished the dividers with some gloss red
rustoleum paint. By using dividers like these, I can keep things
from shifting around during transport.
I lined the front right compartment with foam to keep screwdrivers and
wrenches from rattling around too much.
The rear right compartment was measured to fit and hold my socket, screw
and hex bit set.
The left compartment is for general storage.
If you notice, the back and front wood plates are higher than the rest
in order to provide support rails for a plastic drawer organizer
 
The drawer organizer is suspended over the other compartments and
can slide back and forth to allow access to the compartments below.
|
