To Connect to a Node ---> 

  Enter the Echolink node number directly 

#

Disconnect from current node

*

Station Info

08

Check link status

09

Reconnect to the last node ( Redial )

123

Since  the  N7JND  Echolink   RF  Gateway is normally

connected   automatically    the  B.A.R.T.  system, there

may  be  times when  you  don't  want to be linked to the

B.A.R.T.  system  especially  if  you  are  involved  in  a

lengthy QSO on 145.775 to another node other  than the

B.A.R.T. system. You may want to disable the B.A.R.T

system and prevent it from reconnecting by entering the

following DTMF commands...........

 D0  (zero)  and  then unkey and listen for "Auto Connect

Disabled" response and then send a # sign to disconnect

the B.A.R.T. system. Please re-enable when your QSO is

completed  by  reading  re-enabling  commend  below.

When you have finished your QSO on 145.775 and have

 disconnected  from  your  station, PLEASE re-enable the

Auto Reconnect to  the B.A.R.T. system by sending a D1

from  your  DTMF  pad.  The  system  will respond with a

message  stating  that  Auto  Connect is enabled and you

need to do nothing else. Please  don't  forget to re-enable

this feature.