Here is a picture of the BKL mounts I am using on the Anschutz.  It is the BKL 263 that are 0.7 inches from the bottom of the scope tube, with the BKL 266 risers that add another 0.7 inches.  They are designed for the 11mm European width grooves or the 3/8 inch American.  These mounts are built to work on air rifles so they are solid enough for anything.  I like the way it is divided over the scope tube, it will help to not bind the scope if a screw in the front is slightly tighter or looser than the one in the rear

These are my new mounts from Millett.  The See-Through for rimfire model SE00714.  They seem to be good mounts, time will tell.

Here is a picture from the test target sent with my Anschutz, 10 shots @ 50 meters (55 yards) 8 hits could be identified, the remaining two were into the hole off the edge..... TARGET

Here is a picture of a 7 shot group from 100 yards with my Marlin 880SQ using Remington/Eley Club Extra......... TARGET

Here is a picture from the test target sent with my Anschutz, 10 shots @ 50 meters (55 yards) 8 hits could be identified, the remaining two were into the hole off the edge..... TARGET

This is a 5 shot group from 100 meters using an Anschutz 54.18 and Lapua Midas M ammunition.  I used an AutoCAD program to reference the picture to scale and add the measurements. Here is a link to the original TARGET picture.  Here is the full view of the 11 x 17 target it came from FULLTARGET

This is a second 5 shot group from 100 meters done immediately following the one above and after a slight adjustment in the scope. Here is a link to the original TARGET picture.

HOME ...........  RANGE  RULES ........... RIFLE RULES

CLASSIFICATIONS, SCORING & AWARDS .......... TECHNIQUES 1  

TECHNIQUES 2 .......... TARGETS1 ..... TARGETS2

TESTING & MOUNTS .......... MY WIFE AND I ...... MY SHOOTING HISTORY

SILHOUETTE HISTORY .........SCOPE ADJUSTMENTS AND BALLISTICS

CLEANING ........ CUSTOM ENGRAVING