Variable Manifold Pressure - Digitally Controlled Linear Sensor

Setup for firmware 30120

30 = 3.0 Bar, 1 = 2 Ranges, 2 = Bosch + Precision Mode, 0 = 0 option

All units shipped in Bosch 3.0 bar mode.
Each board has it's own accurate calibration code. If you need an upgrade we need the serial number located on the back of the VMAP.
Ranges are read only during power up.

Jumper In = 1
Jumper Out = 0

Bosch mode – Jumper 1 = 1 (Default)
Precision mode – Jumper 1 = 0

Range Selection

Bar	Jumper 2	Jumper 3	Jumper 4	Jumper 5
2.5	0	0	0	0
3.0	0	0	0	1
3.0	0	0	1	0
3.0	0	0	1	1
3.0	0	1	0	0
3.0	0	1	0	1
3.0	0	1	1	0
3.0	0	1	1	1
3.0	1	0	0	0
3.0	1	0	0	1
3.0	1	0	1	0
3.0	1	0	1	1
3.0	1	1	0	0
3.0	1	1	0	1
3.0	1	1	1	1
3.0	1	1	1	1

Improper use may cause severe engine and or turbo damage. By installing this device you are taking full responsibility for any damage that may occur.

Consult the factory for other applications. If you have any questions please feel free to ask. We also welcome any suggestions.

VMAP Patents Pending
Copyright © 2003 moreboost.com
revision - 6/15/2003